New Holland T8010 Manual page 1655

STEP 15
When the MANUAL format is selected the display
will show the radar icon followed by RADAR CAL.
The bottom of the display will show the previously
saved or default (27.47) calibration number.
1. Use the INCR or DECR keys to change the
number. Decrease the number to increase radar
read out speed and reduce the percentage of slip
displayed during operation. Increase the number
to decrease the read out speed and increase the
percentage of slip display.
2. When the corrected calibration number is
reached, press the PROG key to save that
number.
STEP 16
To use the AUTO format for determining the radar
calibration the following preparations must be made:
1. Mark a straight-line course of 60 meters (196.86
feet) with a start line and finish line that can be
clearly seen from the cab.
2. Position the tractor at an adequate distance from
the start line to allow the tractor to achieve and
maintain a steady speed faster than 2 MPH (3.22
KPH).
Section 55 - Electrical System, Controller - Chapter 6
MD05F018
MD05F019
55-6-10
3. Turn the key switch OFF. Press and hold the
PROG key for 3 seconds within the first 10
seconds of starting the engine.
4. The display will read CONFIG MENU. With ICU
highlighted press the PROG key.
5. The display will show the CONFIG ICU options.
Use the INCR or DECR keys to select Radar Cal
and press the PROG key.
6. The display will show the radar icon followed by
RADAR CAL. The next line reads MANUAL
followed by the manual icon and the bottom line
reads AUTO. Use the INCR or DECR key to
select AUTO and press the PROG key.
STEP 17
When the AUTO format is selected in Step 16 the
display will show the radar icon and RADAR CAL.
The next line reads AUTO and below that *READY*.
The bottom of the screen reads PRESS <INCR> TO
START.
STEP 18
Select a forward gear and engine rpm that will
maintain a steady speed above 2 MPH (3.22 KPA),
release the clutch and press the INCR key when the
front wheels touch the start line. the display will read
*WORKING* and PRESS <DECR> TO STOP.
MD05F020
MD05F021