New Holland T8010 Manual page 1652

STEP 7
The display will read TIRE RADIUS with the radius
icon above the MANUAL or AUTO options. Use the
INCR and DECR keys to select either MANUAL or
AUTO format. Press the PROG key to enter the
selected format.
If MANUAL is selected, proceed to Step 8. If AUTO
(automatic) is selected, proceed to Step 9.
STEP 8
When the MANUAL format is selected the display
will read TIRE RADIUS with the radius icon above
the previously saved radius.
1. Use the INCR or DECR keys to change the
radius number by 1 mm (0.1 inch). Pressing and
holding the INCR or DECR keys will rapidly
change the radius number.
2. When the correct radius number is reached,
press the PROG key to save that number.
Section 55 - Electrical System, Controller - Chapter 6
MD05F010
MD05F011
STEP 9
To use the AUTO format for determining tire radius
the following preparations must be made:
1. Mark a straight-line course of 60 meters (196.86
feet) with a start line and finish line that can be
clearly seen from the cab.
2. Position the tractor at an adequate distance from
the start line to allow the tractor to achieve and
maintain a steady speed faster than 2 MPH (3.22
KPH).
3. Turn the key switch OFF. Press and hold the
PROG key for 3 seconds within the first 10
seconds of starting the engine.
4. The display will read CONFIG MENU and a list of
options. With the ICU highlighted press the
PROG key.
5. The display will read CONFIG MENU followed by
Operator Setup, Controller Config and Exit.
With Operator Setup highlighted press the
PROG key.
6. The display will show the CONFIG ICU options.
Use the INCR or DECR keys to select Tire
Radius and press the PROG key.
7. The display will read TIRE RADIUS with the
ra dius i con above the MANUAL or AUTO
options. Use the INCR or DECR keys to select
AUTO and press the PROG key.
55-6-7
MD0F012