New Holland T8010 Manual page 1658

Configuration/Calibration Mode
STEP 26
The display will read CONFIG ICU, 1. Tractor Model,
2. Fuel Tank, 3. Controller Config and 4. Exit. Use
the INCR or DECR key to highlight 3. Controller
Config and press the PROG key.
NOTE: The 1. Tractor Model or 2. Fuel Tank do not
need to be configured unless the ICU has been
replaced. Use the INCR and DECR key to highlight
and the PROG key to view Tractor Models or fuel
Tank.
If the model number is not correct, use the Electronic
Service Tool configuration window, tractor model
select option to correct the model number.
The display will read MANUAL and AUTO. Use the
INCR or DECR keys to select (highlight) either
MANUAL or AUTO. The default format is MANUAL. If
the MANUAL format is selected the controller menus
must be toggled through and configured into the
system manually. If the AUTO is selected, the
instrumentation controller will check to see which
other controllers are present on the tractor through
the Data Bus.
Section 55 - Electrical System, Controller - Chapter 6
MD05F026
55-6-13
STEP 27
Select between MANUAL or AUTO and press the
PROG key. If AUTO was chosen, the system will go
to Step 36. If MANUAL was chosen, the system will
go to the next step.
STEP 28
The bottom of the display will read SWCD (Color
Display not available at this time). Press the INCR or
DECR key to select NO and press the PROG key.
The system will go to the next step.
MD05F174
MD05F027