New Holland T8010 Manual page 1674

To access these menus:
STEP 1
Push and hold the PROG key for two seconds within
the first ten seconds after starting the tractor. A short
beep will indicate that the program mode has been
accessed and the display will read CONFIG MENU.
STEP 2
P u s h t h e D E C R k ey u n t i l t h e d i s p l ay r e a d s
TRANSMISSION and press the PROG key again.
Section 55 - Electrical System, Controller - Chapter 6
RD05G056
RD06A057
55-6-29
STEP 3
The display will read TRANS VIEW. Press DECR
key.
STEP 4
The display will read TRANS SETUP. Press DECR
key.
RD05F104
RD05F125