Fault Code Retrieval - New Holland T8010 Manual

Hide thumbs Also See for T8010:

Table of Contents

Controllers can be checked for fault codes at any

time. Up to 10 fault codes can be stored in each

With the key switch in the ON or RUN position, press

and hold the DIAG key on the programmable display

key board to enter the controller selection screen.

The display will read DIAG MENU.

Use the DECR key to scroll through the different

controllers: INSTRUMENT (instrument cluster) -

ENGINE - TRANSMISSION - ARMREST - ATC

(automatic temperature control) and AUX/HITCH/

PTO (auxiliary remote hydraulics, three point hitch,

power take off)

NOTE: The Aux/Hitch/PTO controller is also referred

to as the Tractor Multi Function (TMF) controller.

Section 55 - Electrical System, Controller - Chapter 6

FAULT CODE RETRIEVAL

When the required controller is displayed, press the

PROG key. If a controller is selected that is not on the

Data Bus (does not exist), the display will read

Use the INCR and DECR keys to scroll through the

10 possible fault codes. The controller name will be

at the top of the display. The fault code and which

number that fault is (01 to 10), will be at the bottom of

the display.

Table of Contents

T8020 T8030 T8040