New Holland T8010 Manual page 1665

Hide thumbs Also See for T8010:

Table of Contents

Entering Armrest Calibration

NOTE: Programming can only be entered within the

first 10 seconds of turning the key switch to the ON

To get to the armrest controller calibration main

menu, do the following:

Turn the keys switch to the ON position. Push the

program key and hold for two seconds within the first

ten seconds of turning on the key switch. A short

beep will indicate that the program mode has been

accessed and the display will read CONFIG MENU.

Press the DECR key until ARMREST is highlighted.

Press the PROG key to enter the programing menus.

NOTE: If not equipped with a hitch, go to Step 7.

Section 55 - Electrical System, Controller - Chapter 6

Select the calibration option for the hitch control lever

(if equipped). When the display reads ARM HITCH,

press the PROG key.

The display will read H Pos Up. Move the hitch

position lever to the full up position. An asterisk (*)

will appear on the display when the potentiometer is

in a valid range. Press the PROG key to record the

NOTE: Do not go to the transport lock position.

Chapters

Table of Contents

T8020 T8030 T8040