New Holland T8010 Manual page 1666

Hide thumbs Also See for T8010:

Table of Contents

Press the PROG key. The display will read H Pos Dn.

Move the hitch position lever to the full down position.

An asterisk (*) will appear in the display when the

potentiometer is in a valid range. Press the PROG

key to record the voltage.

NOTE: If either the up or down position was not

valid, and the asterisk did not appear in the display,

the display will read cal failed and this calibration

option will abort. A problem will have to be corrected

before calibration will be possible.

Section 55 - Electrical System, Controller - Chapter 6

The display will now read Draft or No Draft. There

must be a hitch load command potentiometer in the

armrest controller to select Draft. Select No Draft

and the hitch will be configured as a position only

hitch. The hitch calibration option is now complete.

Press the PROG key. The display will read ARM

HITCH. To exit the armrest calibration go to Step 23.

Press the DECR key and go to the next step to

continue with armrest calibration.

Chapters

Table of Contents

T8020 T8030 T8040