New Holland T8010 Manual page 1669

STEP 15
The display will read AUX EXT (extend). Move all the
remote hydraulic levers to the full extend position
(Rearward detent). If equipped with a fifth remote
hydraulic section, press and release the fifth remote
hydraulic control switch (momentary) in the extend
direction (rearward).
STEP 16
The display will indicate which levers are in the
extend position with the number of the remote. A
dash (-) indicates that the corresponding lever is not
in the extend position. When completed with all the
levers, press the PROG key. The voltage for all the
levers that are in the extend position will be recorded.
An X will be displayed for any lever that did not have
a valid extend voltage recorded.
Section 55 - Electrical System, Controller - Chapter 6
MD05F111
MD05F112
55-6-24
STEP 17
The display will read AUX RET (retract). Move all the
remote hydraulic levers to the full retract position
(First forward detent).
NOTE: Do not move the lever to the float position.
STEP 18
The display will indicate which levers are in the
retract position with the number of the remote. If the
5th remote was actuated for the extend position, it
need not be actuated again. The number 5 will
already appear on the display. A dash (-) indicates
that the corresponding lever is not in the retract
position. Press the PROG key to record the voltage
for all the levers in the retract position. An X will be
displayed for any lever that did not have a valid
retract voltage recorded.
The remote lever calibration is now complete. Press
PROG and the display will now read ARM AUX
LEVER. To exit the armrest calibration, go to Step
23. Press DECR and go to the next step to continue
with the armrest calibration.
MD05F113
MD05F114