Test Head Interface (Test Head Interface) - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

[G/n][M/μ][k/m] and [×1]
keys (unit keys)
[Alt] key
[Cancel] key
[Back Space] key
[Preset] key

8. Test Head Interface (TEST HEAD INTERFACE)

This interface includes the three ports used to connect the test head: RF OUT, PORT 1, and
PORT 2. All ports are N-type connectors (female).
NOTE
Do not apply DC voltage or DC current to the test head interface as this could result in
damage.
Test Head
The DUT port (see Figure 4-2) corresponds to the IEC61010-1 installation category I.
Figure 4-2 Test Head
Chapter 4
Names and Functions of Parts on the Front Panel
Pressing one of these keys after the numerical value is
entered by a numeric entry key confirms your entry of the
input numerical value assigned to the unit. In other words,
these keys execute the setup. Only two prefixes are labeled
on the surface of each key, and the selection of the prefix
and the type of the unit are automatically determined in
conformity with the parameter to be set. The
allows the setup to be executed without any prefix.
Pressing this key allows you to use the menu bar at the top
of the display screen without using the mouse. Then use the
numeric entry keys to enter the menu number you want to
select or operate the navigation block keys to your desired
menu/submenu.
This key uses the same hardkey as the
dialog box is displayed and this key is pressed, settings
made using this dialog box are cancelled (the key performs
the same function as the
Cancel
Use this key to erase one character of the entered character
string immediately to the left of the cursor position.
Use this key to set the 4287A to an initialized state called
"Preset state."
Function Overview
key
[×1]
[Alt] key. When a
key in the dialog box).
77