Agilent Technologies Twelfth 4287A RF LCR Operation Manual page 175

Table 8-1 Concept of 4287A BIN sort setting (set items for each table)
Sorting condition 1
Measurement point
number
Measurement
parameter
Limit mode
Reference value
BIN 1 Upper limit value
(allows setting Lower limit value
ON/OFF) BIN range mode
BIN 2 Upper limit value
(allows setting Lower limit value
ON/OFF) BIN range mode
BIN 3 Upper limit value
(allows setting Lower limit value
ON/OFF) BIN range mode
: :
BIN 13 Upper limit value
(allows setting Lower limit value
ON/OFF) BIN range mode
Measurement point Selected from the measurement points set according to the measurement point setup table. This is
number set as a measurement point dedicated to BIN sorting, separately from the selection of the
measurement point on the display (single point measurement display or list measurement display)
used to indicate the measurement value.
Measurement As with the setting of the measurement point, set as a measurement parameter dedicated to BIN
parameter sorting, separately from the selection of the measurement parameter on the display (single point
measurement display or list measurement display) used to indicate the measurement value.
Limit mode The mode of selecting the format for inputting limit values (upper limit value and lower limit value)
for each BIN. This mode is selected from three options: absolute mode (ABS: setting the limit value
as an absolute value), percentage mode (PCNT: setting the limit value as a percentage of the
reference value), and deviation mode (DEV: setting the limit value as a difference from the
reference value).
Reference value The reference value used when percentage mode or deviation mode is selected as the limit mode.
Bin ON/OFF Allows the BIN to be turned on (active) and off (inactive). When turned off, the relevant BIN is
inactive (the BIN is regarded as non-existent).
Upper limit value An upper limit value to determine the range of a BIN. The upper limit value must be equal to or
greater than the lower limit value.
Lower limit value A lower limit value to determine the range of a BIN. The lower limit value must be equal to or less
than the upper limit value.
BIN range mode The mode of setting the BIN range according to the limit values (upper limit value and lower limit
value). This mode is selected from three options: In (BIN range at minimum equal to the lower limit
value and at maximum equal to the upper limit value or any range within these values), Out (BIN
range at maximum equal to or less than the lower limit value or at minimum equal to or greater than
the upper limit value), and Off (limit values are irrelevant and entire range is set as BIN range).
Chapter 8
Sorting According to Measurement Results
Sorting condition 2 Sorting condition 3
Measurement point Measurement point
number number
Measurement Measurement
parameter parameter
Limit mode Limit mode
Reference value Reference value
Upper limit value Upper limit value
Lower limit value Lower limit value
BIN range mode BIN range mode
Upper limit value Upper limit value
Lower limit value Lower limit value
BIN range mode BIN range mode
Upper limit value Upper limit value
Lower limit value Lower limit value
BIN range mode BIN range mode
: :
Upper limit value Upper limit value
Lower limit value Lower limit value
BIN range mode BIN range mode
Overview of BIN Sort Function
Sorting condition 4
Measurement point
number
Measurement
parameter
Limit mode
Reference value
Upper limit value
Lower limit value
BIN range mode
Upper limit value
Lower limit value
BIN range mode
Upper limit value
Lower limit value
BIN range mode
:
Upper limit value
Lower limit value
BIN range mode
175