Table of Contents
Advertisement
Setting Measurement Point
The following describes how to set the measurement point for BIN sorting under each
sorting condition (1 to 4).
NOTE
To set the conditions for BIN sorting, the required measurement points should have been
set in the measurement point setup display. If they were not, set the required measurement
points according to Chapter 5 , "Setting Measurement Conditions," on page 101.
Setting of measurement points in BIN sorting is independent of selection of measurement
points in the measurement display (single point measurement or list measurement).
Step 1. Press the
appears (Figure 8-4).
Figure 8-4
BIN sorting setup display
Step 2. Click with the mouse on the desired table number for BIN sort setting in the tool bar at the
bottom of the display.
Step 3. Click in the measurement point (stimulus) cell in the sorting condition to be set (one of
conditions 1 to 4).
Step 4. Click the down arrow () at the right edge of the cell.
Step 5. Click the desired measurement point from the drop-down list box to select it (Figure 8-5).
Chapter 8
key in the measurement block until the BIN SORT setup display
[Setup View]
Sorting According to Measurement Results
Setting Measurement Point
177
Advertisement
Table of Contents
