Setting How The Instrument Displays Measurement Results; Mode) - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Executing Measurements and Displaying Results

Setting How the Instrument Displays Measurement Results

(Enabling/Disabling Deviation Measurement Mode)
Setting How the Instrument Displays Measurement Results
(Enabling/Disabling Deviation Measurement Mode)
You can have the instrument display measurement results as absolute values or as
deviations relative to the reference value (deviation measurement mode). You can change
this setting for each of the measurement parameters 1 through 4. In deviation mode, you
can set the instrument to display deviations as they are (
relative to the reference value (
turned on, Δ symbol is displayed at the left of the measurement parameter.
Figure 7-4 Deviation measurement mode
How the instrument displays measurement results differs according to the modes, as
summarized in the table below.
where
NOTE When you are testing DUTs while using the bin sorting function, the instrument always
displays measurement results as they are, regardless of the above settings. See Figure 6-5,
"4287A's data processing flow" in the programming manual.
164
deviation measurement mode
How measurement results are displayed
and mean the following:
Meas Ref
: Measured value
Meas
: Reference value (
Ref
)
CENTER
mode). When the deviation measurement mode is
% Dev.
OFF
Meas
-
[Prmtr] SETUP DEVIATION
Deviation mode) or as percentages
Deviation % Dev.
Meas Ref –
----------------------------
Meas Ref –
Ref
- -
PRMTR-1 [ ] PRMTR-4 [ ]
Chapter 7
×
100
-