System Recovery; Types Of System Recoveries; Notes On Executing System Recovery - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Setting and Using the Control and Management Facilities

System Recovery

System Recovery
By executing system recovery, you can return the system of the 4287A (the Windows
operating system and the firmware) to the factory state (at the time of purchase

Types of system recoveries

The following two types of system recoveries are available.
 Factory recovery
Returns the contents of the C drive to the factory state.
*2
 User recovery
Returns the contents of the C drive to a user-specified state. To use this function, you
must prepare for recovery in advance. For information on preparation, see "Procedure
to create the user backup image" on page 244 for information on the execution. Also,
see "Procedure to execute the user recovery function" on page 247.

Notes on executing system recovery

Executing system recovery causes the following:
 In addition to the Windows operating system and the firmware, the following settings
of the 4287A are returned to the factory state.
• Network setting
• GPIB setting
• Printer setting
 The driver for the supported printer installed after purchase is deleted.
 You need to execute initial registration again.
Files you created using the save function (files in the D drive) are not affected, but we
recommend backing them up before executing system recovery for precautionary
purposes.
*1.If the hard disk failed and has been replaced after purchase, the state when the replacement
was performed is recovered.
*2.This function is available when the volume label on the hard disk is IZ202 or higher.
240
*1
).
Chapter 11