Change 4 - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Manual Changes
Manual Changes
Function
Deleting the character to
the left of the cursor
Deleting the character to
the right of the cursor
Entering a digit at the
position of the cursor
*1. However, if the OK
NOTE
Each of the network addresses can be set using whole numbers from 0 to 255, separated by
periods (.).
Step 5. Use the following operations to complete or cancel the input.
Function
To accept the input
(execute)
To cancel the input
*1. Same as the key.
[Alt]

Change 4

"Setting the internal Clack" can not be applied. Reffer to the following explation.
Setting the Internal Clock
The 4287A is equipped with an internal clock with clock/date function. The internal clock
is used for recording the date and time when data are stored on a storage device, etc. The
following procedure can be used to set the date and time of the internal clock of the 4287A.
NOTE
Be sure to set the internal clock the first time the power is turned ON after you receive the
instrument.
Follow these steps to set the clock by using only the keys on the front panel, i.e., without
using a keyboard or mouse.
1. Displaying the Setting Date and Time dialog box
288
Front panel
Press .
[Back Space]
(Not possible)
Press ... .
[0][1][2] [9]
or Cancel button is clicked, you will execute Step 5 rather than move the cursor.
Front panel
Move the cursor in the dialog
box to the OK button and then
press , , or .
[×1]
*1
Press , or move the
[Cancel]
cursor in the dialog box to the
button and then press
Cancel
[×1] , , or .
Operation
Keyboard
Press .
[←Backspace]
Press .
[Delete]
Press ... .
[0][1][2] [9]
Operation
Keyboard
Press .
[Enter]
Press .
[Esc]
Mouse
(Not possible)
(Not possible)
(Not possible)
Mouse
Click the button in the
OK
dialog box.
Click the button in
Cancel
the dialog box.
Appendix A