Agilent Technologies Twelfth 4287A RF LCR Operation Manual page 198

Sorting According to Measurement Results
Example of Settings for BIN Sorting
Figure 8-24 Setting the upper limit value for Condition 1 of BIN 1
Step 2. Set the lower limit measurement value for sorting into BIN 1 for Condition 1 by following
this procedure.
a. Click the BIN 1 LowerLimit cell in the Condition 1 column to select the cell.
b. Press the [-][1] keys in the entry block on the front panel (Figure 8-25) and then press
the
Figure 8-25 Setting the lower limit value for Condition 1 for BIN 1
Step 3. Set the BIN range mode for sorting into BIN 1 for Condition 1 to "In".
198
key to enter -1% as the lower limit value for BIN 1.
[×1]
Chapter 8