Table of Contents
Advertisement
Turning ON/OFF Update the LCD Display View
The update function of the LCD display view can be turned ON/OFF.
NOTE
For how to perform the instruction "press the key (softkey) in the softkey menu"
mentioned in the procedure, see "13. Softkeys" on page 87.
Step 1. Press the
Step 2. Press the
softkey menu.
Step 3. Press the
display ON or OFF (the setting toggles with each press of the button).
Softkey Label
UPDATE DISPLAY [ON]
UPDATE DISPLAY [OFF]
When the update of the LCD display is set to OFF, updating of the displayed measurement
parameters is restricted to measurement results. This setting can be used to minimize the
internal processing time. See Table 7-2 on page 168 for details of typical task times.
NOTE
With the Agilent 4287A, updating a softkey label while update of the view on the display is
off, is not guaranteed.
However, in Firmware Rev. 1.20 and later, amendment was made so that only the view of
the
UPDATE DISPLAY [ ]
is turned off.
Thus, when update of the view on the display is turned off by operating the
SERVICE MENU
UPDATE DISPLAY [OFF]
Table 7-1
Display contents when the update of the screen display is turned OFF
Display contents not updated
Display contents updated
Chapter 7
Executing Measurements and Displaying Results
Turning ON/OFF Update the LCD Display View
key on the front panel to display the System softkey menu.
[System]
key in the softkey menu to display the SERVICE MENU
SERVICE MENU
key in the softkey menu to turn the update of the LCD
UPDATE DISPLAY [ ]
softkey is updated even when update of the view on the display
-
UPDATE DISPLAY [ON]
.
Display Status
ON (display contents are updated)
OFF (display contents are not updated)
keys, the softkey view immediately changes to
Title / Error message display
Measurement condition display
Instrument status display
Each measurement parameter
I / V monitor
-
[System]
167
Advertisement
Table of Contents
