Table of Contents
Advertisement
Procedure to execute system recovery
This section describes how to return the contents of the C drive to the factory state.
NOTE
You need the keyboard for this operation.
Step 1. Shut down the 4287A.
Step 2. Connect the keyboard to the 4287A.
Step 3. Insert the disk for the system recovery into the floppy disk drive of the 4287A.
Step 4. Press the standby switch of the 4287A to turn it on.
Step 5. When the screen as shown in the figure below appears, press and hold
keyboard until this screen disappears.
NOTE
After several seconds, the next screen appears automatically even if you do not press any
key, so do not miss it.
If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.
Chapter 11
Setting and Using the Control and Management Facilities
System Recovery
of the
241
Advertisement
Table of Contents
