Preparation For Measurement; Connection Between Test Head And Fixture Stand - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Learning Basic Operations

Preparation for Measurement

Preparation for Measurement

Connection between test head and fixture stand

Connect the test head (with 1-meter cable) and test fixture stand to the 4287A as shown in
Figure 3-2. For details, see "Connecting the DUT When Using Special Test Fixture" on
page 29.
Figure 3-2 Connection between test head and fixture stand
NOTE
Open/short/load calibration at the 7-mm-terminal on the tip of the test head is described
later in this chapter. Here the test fixtures (Agilent Technologies 16196A, etc.) for
connection of the DUT are not installed on the test head.
52 Chapter 3