Table of Contents
Advertisement
Executing Measurements and Displaying Results
Selection of Measurement Parameters in Single Point Measurement Display
Selection of Measurement Parameters in Single Point
Measurement Display
In the single point measurement display, a maximum of four parameters can be
simultaneously displayed for the selected measurement point. Follow these steps to set the
measurement parameters.
Step 1. Press the
Step 2. Select the
MEAS PRMTRS softkey menu.
Step 3. Select the desired measurement parameter number from the softkey menu (
PRMTR-4 [ ]
measurement parameter number will appear.
Step 4. Select the desired measurement parameter from the softkey menu.
NOTE
Instead of performing the key operation
PRMTR-4
160
key of the measurement block to display the Prmtrs softkey menu.
[Prmtr]
SETUP MEAS PRMTRS
), and the measurement parameter selection softkey menu for the selected
Softkey label
|Z|
|Y|
Ls
Lp
Cs
Cp
R
Rs
Rp
Q
D
X
G
B
θz (rad)
θz (deg)
θy (rad)
θy (deg)
described above, it is also possible to display the measurement parameter
key from the softkey menu to display the SETUP
Measurement parameter
Absolute value of impedance
Absolute value of admittance
Equivalent series inductance
Equivalent parallel inductance
Equivalent series capacitance
Equivalent parallel capacitance
Equivalent series resistance
Equivalent series resistance
Equivalent parallel resistance
Quality factor
Dissipation factor
Equivalent series reactance
Equivalent parallel conductance
Equivalent parallel susceptance
Impedance phase (radian)
Impedance phase (deg.)
Admittance phase (radian)
Admittance phase (deg.)
[Prmtr]
-
SETUP MEAS PRMTRS
PRMTR-1 [ ]
to
-
PRMTR-1
to
Chapter 7
Advertisement
Table of Contents
