Setting The Measurement Point Number, Measurement Parameter, And Bin Range Setting Mode For Condition 2 - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Sorting According to Measurement Results
Example of Settings for BIN Sorting
Setting the measurement point number, measurement parameter, and
BIN range setting mode for Condition 2
Step 1. In the same manner as for Condition 1, set the measurement point number for Condition 2
by following this procedure.
a. Click with the mouse the measurement point number (Stimulus) cell in the Condition 2
column to select the cell.
b. Click the down-arrow  that appears in the right side of the cell.
c. In the drop-down list box that appears, click "(3) 100.00 MHz" (Figure 8-22).
Figure 8-22 Setting the measurement point number (Stimulus) for Condition 2
Step 2. Set the measurement parameter for Condition 2 as follows.
a. Click the measurement parameter (Parameter) cell in the Condition 2 column to select
the cell.
b. Click the down-arrow  that appears in the right side of the cell.
c. In the drop-down list box that appears, click "Q" (Figure 8-23).
196 Chapter 8