Configuring The Network; Enabling/Disabling Network - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Setting and Using the Control and Management Facilities

Configuring the Network

Configuring the Network
NOTE
When you use the 4287A by connecting it to your LAN, consult your network
administrator and make the setting of the LAN correctly.
This section describes how to set the following basic items necessary to connect the 4287A
to the LAN (Local Area Network).
 "Enabling/disabling network" on page 228
 "Setting IP address" on page 229
 "Specifying computer name" on page 231
If you need detail network settings, consult your network administrator and perform
operation in the same way as the Windows 2000® PC.

Enabling/disabling network

You can enable/disable the network connection function of the 4287A.
Follow these steps to enable/disable the network connection function.
Step 1. Use the LAN cable to connect the 4287A to the LAN.
Step 2. Press
Step 3. Press
Step 4. Press
(Figure 11-2). Press OK in the warning dialog box.
Figure 11-2 Network and Dial-up Connections window
228
.
.
LAN Setup
Network Configuration
to open the Network and Dial-up Connections window
Chapter 11