Names And Functions Of Display Areas On The Lcd Display - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Function Overview

Names and Functions of Display Areas on the LCD Display

Names and Functions of Display Areas on the LCD Display
The 4287A LCD display screens include the six types of displays (two measurement
displays and four setup displays) explained in Table 4-1.
Table 4-1 Types of 4287A displays
Display type
Single-point measurement
display
Measurement
List measurement display
display
Measurement point setup
display
Calibration kit setup
Setup display
display
Compensation kit setup
display
Bin sorting setup display
82
Measurement is done at the specified single measurement point
and the result is shown on this display.
All measurements are preset in the specified table according to
the sequence of the measurement point numbers and are listed
on the display.
A display for setting up measurement points. The required
measurement points are set sequentially, starting from
measurement point number 1, by inputting measurement
conditions (measurement frequency, averaging factor and test
signal level). A maximum of 32 measurement points can be set
in each of the eight tables.
A display for setting up the calibration kit definition (value) for
the measurement point set up on the measurement point setup
display.
A display for setting up the compensation kit definition (value)
for the measurement point set up on the measurement point
setup display.
A display for setting up the conditions for bin sorting (sorting by
measurement result).
Function
Chapter 4