Table of Contents
Advertisement
Setting and Using the Control and Management Facilities
System Recovery
Procedure to create the user backup image
This section describes how to create the user backup image. The C drive contents saved in
this creation are recalled when the user recovery function is executed.
NOTE
This function is available when the volume label on the hard disk is IZ202 or higher.
NOTE
You need the keyboard for this operation.
Step 1. Shut down the 4287A.
Step 2. Connect the keyboard to the 4287A.
Step 3. Insert the disk for the system recovery into the floppy disk drive of the 4287A.
Step 4. Press the standby switch of the 4287A to turn it on.
Step 5. When the screen as shown in the figure below appears, press and hold
until this screen disappears.
NOTE
After several seconds, the next screen appears automatically even if you do not press any
key, so do not miss it.
If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.
244
of the keyboard
Chapter 11
Advertisement
Table of Contents
