Agilent Technologies Twelfth 4287A RF LCR Operation Manual page 106

Setting Measurement Conditions
How to Set the Measurement Point
Figure 5-4 Addition of measurement frequency
NOTE
If you add frequency as a new measurement point, the same settings of the averaging factor
and oscillator level as those of the previous measurement point are automatically input.
If you press the
key on the keyboard after entering the value without specifying the unit, the same unit as
that of the above cell is entered as the default value. To change the unit, perform any of the
following operations before pressing any of the above keys.
•
•
•
•
Step 3. Repeat Steps 1 and 2 to add the required measurement points (Figure 5-5).
106
key,
[×1]
Press the or key in the navigation block on the front panel the required
number of times to change the unit.
Turn the rotary knob (
to change the unit.
Press the [↑] or [↓] key on the keyboard connected to the 4287A the required number of
times to change the unit.
Using the mouse connected to the 4287A, left-click the down-arrow  to the right of
the unit indication, and then select the unit from the pull-down menu that appears.
key, or rotary knob (
) in the navigation block on the front panel to the left or right
) on the front panel or the
Chapter 5
[Enter]