Table of Contents
Advertisement
List measurement display
The point measurement display shown in Figure 4-6 appears when you press the
View]
Figure 4-6
List measurement display
1. Measurement point number
This is the number of the measurement point set in the measurement point setup display.
The displayed values of measurement frequency (FREQ), oscillator level (POWER),
averaging factor (AVG), test signal current monitor value (I-mon), and test signal voltage
monitor value (V-mon) shown in the upper area of the display are for the selected
(highlighted) measurement point number.
2 to 5. Labels 1 to 4
You can select one parameter for each of the four labels from among the following and
display the parameter's value in the corresponding column.
•
Measurement parameter 1 (the top measurement parameter shown in the "Single point
measurement display" on page 84),
•
Measurement parameter 2 (the second measurement parameter shown in the "Single
point measurement display" on page 84),
•
Measurement parameter 3 (the third measurement parameter shown in the "Single
point measurement display" on page 84),
•
Measurement parameter 4 (the bottom measurement parameter shown on the "Single
point measurement display" on page 84).
•
Test signal voltage monitor value (V-mon)
Chapter 4
Names and Functions of Display Areas on the LCD Display
key once or twice.
Function Overview
[Meas
89
Advertisement
Table of Contents
