Table of Contents
Advertisement
Figure 8-23
Setting the measurement parameter (Parameter) for Condition 2
NOTE
The setting mode for the range for sorting in Condition 2 is not changed from the default
setting "ABS" (absolute value setting). When set with an absolute value, the reference
value is not required and "--------" is indicated in the "Nominal" cell.
Setting the measurement value range for sorting into BIN 1 to BIN 3
After setting the measurement point number, measurement parameter, and BIN range
setting mode for both Condition 1 and Condition 2, set the measurement value range for
sorting into BIN 1 to BIN 3.
Step 1. Set the upper limit measurement value for sorting into BIN 1 for Condition 1 by following
this procedure.
a. Click with the mouse the BIN 1 UpperLimit cell in the Condition 1 column to select the
cell.
b. Press the [1] key in the entry block on the front panel (Figure 8-24) and then press the
[×1]
Chapter 8
key to enter + 1% as the upper limit value for BIN 1.
Sorting According to Measurement Results
Example of Settings for BIN Sorting
197
Advertisement
Table of Contents
