Table of Contents
Advertisement
Executing Measurements and Displaying Results
Selection of Display Parameters in List Measurement Display
Selection of Display Parameters in List Measurement
Display
In the list measurement display, a maximum of four parameters can be simultaneously
displayed for the listed measurement points. Follow these steps to set the list display
parameters.
Step 1. Press the
menu in the list measurement display.
Step 2. Select the
parameter setup softkey menu.
Step 3. Select the desired list display label (
and the display parameter selection softkey menu for the selected label will appear.
Step 4. Select the desired display parameter from the softkey menu.
NOTE
Instead of performing the key operation
LABEL-4 [ ]
heading ("2 to 5. Labels 1 to 4" on page 89) on the display; this immediately displays the
selected label's parameter selection softkey menu.
162
key in the measurement block to display the parameter setup softkey
[Prmtr]
SETUP LIST PRMTRS
Softkey label
*1
PRMTR-1
*1
PRMTR-2
*1
PRMTR-3
*1
PRMTR-4
V-mon
I-mon
FREQ
AVG
POWER
R_dc
*1. The four measurement parameters set to show up on the single point measurement dis-
play are indicated as softkey labels in brackets.
as described above, you can directly click on a list display parameter's column
key from the softkey menu to display the list display
to
LABEL-1 [ ]
LABEL-4 [ ]
List display parameter
The measurement parameter set as measurement
parameter 1
The measurement parameter set as measurement
parameter 2
The measurement parameter set as measurement
parameter 3
The measurement parameter set as measurement
parameter 4
Test signal voltage level monitor value
Test signal current level monitor value
Measurement frequency
Averaging factor
Test signal level (power)
DC resistance measurement value
[Prmtr]
-
SETUP LIST PRMTRS
) from the softkey menu,
-
LABEL-1 [ ]
to
Chapter 7
Advertisement
Table of Contents
