How To Install Rackmount Kit (Option 1Cm) - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Installation Guide
How to Install Front Handles/Rack Mounting Flanges
Figure 2-4 How to install modified trim strip
WARNING If the installed front handle becomes damaged, replace it with a new one immediately.
A damaged handle can break while moving or lifting the instrument and cause
personal injury or damage to the instrument.

How to install rackmount kit (Option 1CM)

Install the rackmount kit by following these steps:
Step 1. Make sure that all of the contents of the rackmount kit (Option 1CM) have been supplied in
the shipping container (Table 2-4).
Table 2-4 Contents of rack-mount kit (Option 1CM)
Step 2. Remove the trim strips from both sides of the outer frame of the Agilent 4287A front panel.
24
Rackmounting flange (locking side plate)
Screw
Name Quantity
2
6
Chapter 2