Agilent Technologies Twelfth 4287A RF LCR Operation Manual page 87

Names and Functions of Display Areas on the LCD Display
13. Softkeys
The softkeys are shown here. To operate the softkeys, first press the
the key described in "5. Measurement block (MEASUREMENT)" on page 75, or
[Prmtr]
the keys described in "6. Instrument state block (INSTR STATE)" on page 76 to call up the
desired softkey menu. Then select the desired softkey using any of the following methods:
 Turn the rotary knob
vertically move the selection cursor over the softkey label. Then press the rotary knob
to select the softkey.
 Press the
keys on the front panel to vertically move the selection cursor
over the softkey label. Then press
 Click the softkey label with the mouse connected to the 4287A.
 Press the arrow keys (
[↑]
move the selection cursor over the softkey label. Then press the
the softkey.
14. Date/time
Displays the current date and time. For details on how to set the date and time (including
turning the indication on or off), see "Initial Registration of 4287A" on page 40.
15. Equipment status
Displays the status of crucial operating conditions of the 4287A.
Display
(red display)
UnCal
(blue display)
Cor
(blue display)
Cmp
(blue display)
Del
(blue display)
Int
(blue display)
Man
Ext (blue display)
Bus (blue display)
Chapter 4
on the front panel clockwise or counterclockwise to
to select the softkey.
and ) of the keyboard connected to the 4287A to vertically
[↓]
Definition
Calibration not executed.
Calibration executed.
Compensation executed.
Fixture compensation (electrical length and delay time
compensation) has been set (a value other than 0 has been
set for the electrical length of the fixture).
The trigger mode is internal trigger mode (free run). The
4287A itself executes the trigger continuously.
The trigger mode is manual trigger mode. Trigger is
executed when the [Trigger]
pressed.
The trigger mode is external trigger mode. Trigger is
executed by a signal sent through the external trigger input
terminal or the handle interface.
The trigger mode is bus trigger mode. Trigger is executed
via GPIB or LAN.
Function Overview
[Stml Select] key or
key to select
[ENTER]
key on the front panel is
87