Agilent Technologies Twelfth 4287A RF LCR Operation Manual page 249

Step 8. The message as shown below appears. Press
user recovery, press
You chose to recover your own system backup image file.
WARNING: Press C to Continue only if you are sure that you want
to proceed. The C: partition will be completely overwritten with no
chance of recovering any data.
from a serious malfunction caused by corrupted or inadvertently
deleted files on the system's primary C: partition.
Press C to Continue or E to Exit: _
Step 9. The message as shown below appears. Press
If you want to cancel the user recovery, press
CAUTION! Interrupting this process may leave the system in an
Press C to Continue or E to Exit: _
CAUTION
Never turn off the power during the system recovery because doing so may cause
serious damage to the 4287A.
Step 10. The user recovery will be complete in about 5 minutes. When the user recovery is
complete, the message as shown below appears. Press
keyboard at the same time to restart.
Remove the disk and Press CLT+ALT+DEL to restart your
system.
NOTE If the above message does not appear, the instrument is at fault; contact your local Agilent
customer center listed at the end of this manual or distributor.
Chapter 11
Setting and Using the Control and Management Facilities
here.
unstable state. Allow the software to complete the
backup and recovery process.
minutes depending on the system configuration.
System Recovery
of the keyboard. If you want to cancel the
Use Option 3 to recover the system
of the keyboard to start the user recovery.
here.
This may take up to 20
, , and of the
249