Example Of Settings For Bin Sorting - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Sorting According to Measurement Results

Example of Settings for BIN Sorting

Example of Settings for BIN Sorting
The following introduces an example of setting an actual BIN sort setting table. The
sorting conditions to be set are shown in Table 8-2.
Table 8-2 Sorting conditions
BIN
BIN 1
BIN 2
BIN 3
OUT OF
BINS
NOTE
When both Condition 1 and Condition 2 of Table 8-2 are met, the DUT is placed in the
appropriate BIN.
In Table 8-2, "" denotes that this point is included, and "" denotes that this point is not
included.
Perform the following steps to set these conditions in the 4287A.
192
Condition 1
Measurement point number: 3 (100 MHz)
Measurement parameter: Ls
Condition 2
Measurement point number: 3 (100 MHz)
Measurement parameter: Q
Chapter 8