Table of Contents
Advertisement
Now the system recovery of the 4287A is complete.
NOTE
If the problem persists even after executing system recovery, the 4287A is at fault; contact
your local Agilent customer center listed at the end of this manual or the distributor from
which you purchased the instrument.
Change 5
"Configuring the network" can not be applied. Reffer to the following explation.
Checking and Editing the LAN Settings
The following explains how to set the necessary addresses and other settings required for
using the LAN (Local Area Network) functions of the 4287A. For details on LAN
functions, see the Programming Manual.
Checking and editing the network addresses
The 4287A network addresses (IP address, Gateway address, Sub Net Mask) can be
checked and edited by the following procedure (IP: Internet Protocol).
NOTE
For how to perform the instruction "press the key (softkey) in the softkey menu"
mentioned in the procedure, see "13. Softkeys" on page 87.
Step 1. Press the
Step 2. Press the
Step 3. Press the
Setup dialog box (Figure A-2).
Figure A-2
Network Address Setup dialog box
Step 4. Perform the following operations to enter the IP address, Gateway address and Net Mask
address in their respective input boxes of the dialog box.
Function
Moving the cursor
Turn
press
Appendix A
[System]
key on the front panel to display the System softkey menu.
LAN SETUP
key in the softkey menu to display the LAN SETUP softkey menu.
SETUP IP ADDRESS
key in the softkey menu to display the Network Address
Front panel
Press
[Tab][↑][↓][←][→]
, or
.
Operation
Keyboard
.
Click the position where the
cursor should be moved to.
Manual Changes
Manual Changes
Mouse
*1
287
Advertisement
Table of Contents
