How To Install Rack-Mount And Handle Kit (Option 1Cp) - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Installation Guide
How to Install Front Handles/Rack Mounting Flanges
Figure 2-7 How to remove bottom feet and tilt stands
Step 5. Mount the Agilent 4287A on the rack.

How to install rack-mount and handle kit (Option 1CP)

Install both the rack-mounting flanges and front handles by following these steps:
Step 1. Make sure that all of the contents of the rack-mount and handle kit (Option 1CM) have
been supplied in the shipping container (Table 2-5).
Table 2-5 Contents of rack-mount and handle kit (Option 1CP)
Step 2. Remove the trim strips from both sides of the outer frame of the Agilent 4287A front panel.
26
Rack-mounting flange (locking side plate)
Front handle
Screw
Name Quantity
2
2
8
Chapter 2