Table of Contents
Advertisement
How to add measurement points
The measurement point number 1 of each table (1 to 8) has data consisting of a frequency
of 1 MHz, averaging factor of 1, and oscillator level of -13.0 dBm as a preset state.
To add new measurement points to those already entered in the specified table, perform the
following steps.
Step 1. Use the mouse to select the cell one level below the already entered frequency cell (a
selected cell is called an active cell; it is enclosed in a thick-bordered box indicating that
the cell is selected for data entry (Figure 5-3)).
Figure 5-3
Selection of frequency cell for new measurement point to be added
NOTE
Selectable cells are displayed more brightly than other cells.
Step 2. Press the numeric entry keys (
in the entry block sequentially to enter the frequency of the measurement point to be added.
To enter 2 MHz, for example, press
Chapter 5
Setting Measurement Conditions
How to Set the Measurement Point
[0]
to
[9]
and
[.]
) and a unit key (
[2]
(Figure 5-4) and
[M/μ]
[G/n]
,
[M/μ]
,
[k/m]
or
[×1]
)
sequentially.
105
Advertisement
Table of Contents
