Starting And Stopping Printing - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Printing Out Measurement Results and Internal Data on a Printer
Step 2. Press
NOTE
When you use the DeskJet 930C, select "HP DeskJet 970C Series".
Step 3. Press
button.
Step 4. Press
NOTE
To cancel the printer selection, move the cursor to the Cancel button in Step 3. Then press
unchanged from the last time a selection was made.

5. Starting and stopping printing

Step 1. Check that the printer is properly connected to the printer parallel port on the rear panel of
the 4287A.
Step 2. Check that paper is properly loaded in the printer.
Step 3. Check that the printer is turned ON.
Step 4. Turn the rotary knob
PRINT
NOTE
If you have selected
the clipboard before starting print.
When there is no saved image on the clipboard, the image at the start of print is printed.
Therefore, if you start print with the menu bar at the top of the screen using a mouse and
the like, the pull-down menu displayed for the operation may partly hide the image you
want to print. To avoid this, before starting print, press
it) with the image you want displayed to save the image to the clipboard.
NOTE
To stop printing after it has been started, turn the rotary knob
move the cursor in the softkey menu to
printing.
318
or on the front panel to highlight the desired printer model.
on the front panel the required number of times to move the cursor to the OK
on the front panel to close the Available Printers dialog box.
to close the Available Printer dialog box. In this case, the printer selection remains
on the front panel to move the cursor in the softkey menu to
. Then press to start printing.
CONTENT [SCREEN]
as the item to be printed, save the image to
[Display]
. Then press
ABORT PRINTING
( is shown above
Capture
on the front panel to
to stop
Appendix E