Setting Measurement Parameter - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Setting Measurement Parameter

After setting the measurement point number, select the measurement parameter for BIN
sorting.
NOTE Similar to setting the measurement point, selecting the measurement parameter in BIN
sorting is independent of the selection of the measurement parameter in the measurement
display (single point measurement or list measurement).
Step 1. Click with the mouse in the measurement parameter cell in the sorting condition to be set
(one of conditions 1 to 4).
Step 2. Click the down arrow () at the right edge of the cell.
Step 3. Click the desired measurement parameter from the drop-down list box to select it (Figure
8-6).
BIN sort measurement parameter
Ls
Lp
Cs
Cp
Rs
Rp
Q
D
G
B
X
|Z|
|Y|
θz (rad)
θz (deg)
θy (rad)
θy (deg)
Click on  in the upper-right or  in the lower-right part of the list box or use the scroll
NOTE
thumb to scroll the list.
Chapter 8
Sorting According to Measurement Results
Setting Measurement Parameter
Definition
Equivalent series inductance
Equivalent parallel inductance
Equivalent series capacitance
Equivalent parallel capacitance
Equivalent series resistance
Equivalent parallel resistance
Quality factor
Dissipation factor
Equivalent parallel conductance
Equivalent parallel susceptance
Equivalent series reactance
Absolute value of impedance
Absolute value of admittance
Impedance phase (radian)
Impedance phase (deg.)
Admittance phase (radian)
Admittance phase (deg.)
179