Table of Contents
Advertisement
Sorting According to Measurement Results
Bin Count Function
Bin Count Function
Effective from
The Bin Count function counts the frequency by incrementing the bin count corresponding
Firmware Rev. 1.20
to the Bin Sorting result by 1 each time measurement ends. The frequency of each bin can
be viewed on the display when necessary.
Turning on Bin Count
If Bin Count is turned on, the bin frequency corresponding to the result is incremented by 1
each time Bin Sorting is run by measurement.
Bin Count can be turned on using the following procedure:
Step 1. In the front panel Measurement Block, press the
menu.
Step 2. In the softkey menu, press the
softkey menu.
Step 3. In the softkey menu, press the
NOTE
Even when Bin Count is turned on, the counter value is unchanged unless Bin Sorting is
actually run. For using the Bin Sorting function, refer to Chapter 8, "Sorting According to
Measurement Results" in the Operation Manual.
Listing the BIN Count results
The Bin Count results can be listed on the LCD display by using the following procedure:
Step 1. In the front panel Measurement Block, press the
menu.
Step 2. In the softkey menu, press the
softkey menu.
Step 3. In the softkey menu, press the
190
softkey label
COUNT[ON]
COUNT[OFF]
[Prmtr]
BIN COUNT MENU
to display the BIN COUNT MENU
key to turn on Bin Count.
COUNT [ ]
Status of Bin Count
On
Off
[Prmtr]
BIN COUNT MENU
to display the BIN COUNT MENU
DISPLAY
key to list the BIN Count results (see Figure 8-16).
key to display the Prmtrs softkey
key to display the Prmtrs softkey
Chapter 8
Advertisement
Table of Contents
