Table of Contents
Advertisement
Sorting According to Measurement Results
Setting Limit Mode and Reference Value
Setting reference value
When you select percentage mode (
must set the reference value (Nominal).
NOTE
When you select absolute mode (
reference value (nominal). Actually, this value cannot be set in ABS mode.
Step 1. Click with the mouse in the reference value (Nominal) cell in the sorting condition to be set
(one of conditions 1 to 4). (Before doing this, make sure the limit mode is set as PCNT or
DEV.)
Step 2. Press the entry block numeric keys (
press the desired unit key (
To enter 50 nH, for example, press
Figure 8-8
Entering BIN limit setting reference value for sorting condition 1
182
) or deviation mode (
PCNT
ABS
) as the BIN limit mode, you do not need to set the
[0]
to
[9][-][.]
) to enter the reference value and then
,
,
, or
[G/n]
[M/μ]
[k/m]
[×1]
[5], [0]
, and then
) as the limit mode, you
DEV
).
[G/n]
(Figure 8-8).
Chapter 8
Advertisement
Table of Contents
