To Display Measurement Data-One Channel, One Trace - Agilent Technologies 35670A Operator's Manual

Agilent 35670A
Operator's Guide
To display measurement data—one channel, one trace
1
Activate a single trace.
2
Press [ ], then press [
Meas Data
channel whose data you want to display.
3
Press the softkey corresponding to the measurement data you want to display.
Settings under the [
Inst Mode
•
The instrument mode selection. Not all measurement data is available for every
instrument mode. Autocorrelation data, for example, is available only when
[
CORRELATN ANALYSIS
•
The [
CHANNELS 1 2
example, frequency response—requires data from two channels. This type of
measurement data is available only if the active channels softkey is set to 2 or 4.
•
The [
REF CHANS 1 1,3
that requires two channels and uses channel 3 as the reference for channel 4, is
available only when the reference channels softkey is set to 1,3.
] (or [
CHANNEL 1 2
] hardkey control the availability of measurement data:
] is selected.
] (or [ ]) setting. Some measurement data—for
CHANNELS 1 2 4
] setting (four-channel analyzers only). Measurement data
Displaying Measurement Data
]) to highlight the
CHANNEL 1 2 3 4
8-3