How To Install The Rack-Mount Kit (Option 1Cm); How To Install The Rack-Mount And Handle Kit (Option 1Cp) - Agilent Technologies E5070A ENA Series Installation And Quick Start Manual

How to Install the Rack-mount Kit (Option 1CM)

The rack-mount kit includes two flanges (locking side plates) for mounting the
E5070A/E5071A on a rack (482.6 mm/19 inches) conforming to the EIA Standard. While
referring to Figure 2-4, install the rack-mount kit by following these steps.
Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frame of the
E5070A/E5071A front panel.
Step 2. Use the provided screws to mount a rack-mounting flange (4) on each side of the
E5070A/E5071A front panel frame.
Step 3. Remove the four bottom feet of the E5070A/E5071A (lift the bar marked TAB on the inner
side of the foot and slide the foot toward the bar).
Step 4. Mount the E5070A/E5071A on the rack.

How to Install the Rack-mount and Handle Kit (Option 1CP)

The rack-mount and handle kit includes both the rack-mounting flanges (locking side
plates) and front handles. While referring to Figure 2-4, install the rack-mount kit by
following these steps.
Step 1. Remove the adhesive-backed trim strip (1) from each side of the outer frame of the
E5070A/E5071A front panel.
Step 2. Use the provided screws to mount a front handle (2) and rack-mounting flange (4) on each
side of the E5070A/E5071A front panel frame.
Step 3. Remove the four bottom feet of the E5070A/E5071A (lift the bar marked TAB on the inner
side of the foot and slide the foot toward the bar).
Step 4. Mount the E5070A/E5071A on the rack.
Chapter 2
Installing Front Handles/Rack Mounting Flanges
Installation
23