Option 1Cn Handle Kit; Installing The Handle; Option 1Cm Rack Mount Kit; Mounting The Rack - Agilent Technologies E5100A User Manual

Option 1CN Handle Kit

Option 1CM Rack Mount Kit

Option 1CP Rack Mount & Handle Kit
Option 1CN is a handle kit containing a pair of handles and the
necessary hardware to attach them to the instrument.

Installing the Handle

1. Remove the adhesive-backed trim strips
front sides of the E5100A/B. (Refer to Figure 3-2.)
2. Attach the front handles
3. Attach the trim strips
Option 1CM is a rack mount kit containing a pair of anges and the
necessary hardware to mount them to the instrument in an equipment
rack with 482.6 mm (19 inches) horizontal spacing.

Mounting the Rack

1. Remove the adhesive-backed trim strips
front sides of the E5100A/B. (Refer to Figure 3-2.)
2. Attach the rack mount ange
the E5100A/B using the screws provided.
3. Remove all four feet (lift bar on the inner side of the foot, and
slide the foot toward the bar.)
Option 1CP is a rack mount kit containing a pair of anges and the
necessary hardware to mount them to an instrument which has
handles attached, in an equipment rack with 482.6 mm (19 inches)
spacing.

Mounting the Handle and Rack

1. Remove the adhesive-backed trim strips
front sides of the E5100A/B. (Refer to Figure 3-2.)
2. Attach the front handle
on the left and right front sides of the E5100A/B using the screws
provided.
3. Remove all four feet (lift bar on the inner side of the foot, and
slide the foot toward the bar).
1
to the sides using the screws provided.
3
to the handles.
4
1
to the left and right front sides of
2
1
and the rack mount fringe
3
Installation and Set Up Guide
from the left and right
from the left and right
from the left and right
together
5
3-7