Table of Contents
Advertisement
Color Calibration
This procedure describes how to check that the cartridges are
properly aligned for color plotting and should be followed each time
the ink cartridges are installed. Figure 3-18 is a representation of
how a color calibration looks when printed.
The measurement of 0.075" instead of 0.065" as stated
earlier is used due to the fact that the test cartridge
does not contain a jet plate assembly. A 0.010" differ-
ence had to be added to compensate for the lack of a
jet plate assembly on the test cartridge.
8. Tighten the screw on the left side of the stabilizer.
9. While lifting up the measuring tip of the micrometer, slide
the Carriage to the right until the next stabilizer screw is
lined up. Position it as close to the screw as possible and drop
the measuring tip onto the platen. Do this a couple of times to
ensure an accurate reading.
10. Move the left end of the stabilizer bracket until a reading of
0.075" +/- 0.003" is observed. Read only the RED numbers on
the micrometer gauge.
11. Tighten the screw on the stabilizer that is next to the
Carriage.
12. Continue performing steps 10 through 12 until all four of the
stabilizer screws have been adjusted.
13. Reposition the Carriage to all of the adjustment positions and
verify that the measurements are correct.
14. Perform steps 6 through 14 as many times as necessary to
correctly accomplish this adjustment.
NOTE
Advertisement
Table of Contents
Troubleshooting
