Remove The Lower Roller Assembly, Stepper Motor And Vacuum Fan - ENCAD 60e Service Manual

Remove the Lower Roller Assembly, Stepper
Motor and Vacuum Fan
The Inner Platen contains the Lower Drive Roller Assembly, the
Vacuum Fan Assembly, the Stepper Motor Assembly, Drive Shaft
Supports, and the Foam Block. These parts are collectively
referred to as the Inner Platen Parts.
1. Perform steps 1 through 13 of the Remove the Left, Top, and
Right Covers procedures to remove the Left, Top and Right
Covers.
2. Perform steps 2 through 4 of the Remove Servo Motor
procedures to remove the Right Sideplate Assembly.
3. Perform steps 2 through 5 of the Remove Service Station
procedures to remove the Service Station.
4. Using the accesses gained by removing the Right Sideplate
and the Service Station, remove the foam block from between
the Lower Drive Roller Assembly and the Servo Motor.
5. Perform steps 2 through 6 of the Remove the Ink Delivery
NOTE
The removal of the Lower Drive Roller Assembly
and Vacuum Fan(s) is easier if extracted out of the
left side of the Platen.
Be careful when removing the Foam Block so that it
does not tear. It is very important to have an intact
Foam Block to produce sufficient vacuum inside the
Platen to properly hold down the media.
Novajet PROe Series Service Manual
Assembly\Disassembly 139