Remove The Lower Roller Assembly, Stepper Motor And Vacuum Fan - ENCAD NovaJet Pro 600e Service Manual

Remove the Lower Roller Assembly, Stepper
Motor and Vacuum Fan
The Inner Platen contains the Lower Drive Roller Assembly, the
Vacuum Fan Assembly, the Stepper Motor Assembly, Drive Shaft
Supports, and the Foam Block. These parts are collectively referred to
as the Inner Platen Parts.
1. Perform steps 1 through 13 of the Remove the Left, Top, and Right
Covers procedures to remove the Left, Top and Right Covers.
2. Perform steps 2 through 4 of the Remove Servo Motor procedures to
remove the Right Sideplate Assembly.
3. Perform steps 2 through 5 of the Remove Service Station procedures
to remove the Service Station.
4. Using the accesses gained by removing the Right Sideplate and the
Service Station, remove the foam block from between the Lower
Drive Roller Assembly and the Servo Motor.
5. Perform steps 2 through 6 of the Remove the Ink Delivery System
procedures to remove the Ink Delivery System.
NOTE
The removal of the Lower Drive Roller Assembly and
Vacuum Fan(s) is easier if extracted out of the left side of
the Platen.
Be careful when removing the Foam Block so that it does
not tear. It is very important to have an intact Foam
Block to produce sufficient vacuum inside the Platen to
properly hold down the media.
NovaJet PRO 600e Service Manual
Assembly\Disassembly 5-43