Remove The Stabilizer Bracket And Encoder Strip - ENCAD 60e Service Manual

7. If the Carrier Assembly is installed, insert the Trailing Cable
Assembly into the Strain Relief Assembly. Insert the Strain
Relief (with Trailing Cable) onto the Carrier Assembly by
sliding it onto the Strain Relief Support until it snaps firmly
into place. See Figure 5-4.

Remove the Stabilizer Bracket and Encoder Strip

1. Perform steps 1 through 13 of the Remove the Left, Top, and
Right Covers procedures to remove the Left, Top and Right
Covers.
2. Perform steps 2 through 6 of the Remove the Ink Delivery
System procedures to remove the Ink Delivery System.
3. Perform the Remove the Carrier Assembly, Carrier Belt, and
the Frame Tensioner procedures to remove the Carrier
Assembly from the Slide Shaft.
4. Perform steps 3 and 4 of the Remove the Trailing Cable
Assembly procedures to remove the Trailing Cable Assembly.
5. Remove the Support Bracket by slightly tilting the top of the
Support Bracket towards the front of the printer and lifting
it straight up. See Figure 5-21.
Novajet PROe Series Service Manual
Assembly\Disassembly 133