Remove The Stabilizer Bracket And Encoder Strip - ENCAD NovaJet 800 Series Service Manual

6. Reposition the Floating Carriage Cover/Right Support Bracket
Assembly and the Left Support Bracket around the Carriage
Assembly. Secure the Left Support Bracket to the Floating Carriage
Assembly. Torque to 15 in-lbs.
7. Install the Top and Right Covers following procedures outlined earlier
in this chapter.

Remove the Stabilizer Bracket and Encoder Strip

1. Remove the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
2. Remove the Ink Delivery System, Carriage Assembly and Trailing
Cable Assembly following procedures outlined earlier in this chapter.
3. Remove the Chain Support Bracket by slightly tilting the top of the
Chain Support Bracket towards the front of the printer and lifting it
straight up. See Figure 5-27.
Figure 5-27. Stabilizer Bracket Installation/Removal.
NovaJet 800 Series Service Manual
CHAIN SUPPORT
BRACKET RESTS
ON THE TOP
OF THE Y-ARM
ASSEMBLY
Assembly\Disassembly 5-43