Remove Extra Memory (Simm) - ENCAD NovaJet Pro 600e Service Manual

Remove Extra Memory (SIMM)

1. Perform steps 1 through 9 of the Remove the Left, Top, and Right
Covers procedure to remove the Top and Right Covers.
Figure 5-5. Extra Memory (SIMM) Installation/Removal.
2. The SIMM slots are at a 90° angle from the main circuit board.
Facing the top of the SIMM, push the side clips gently to the
outside (away from the SIMM) then push the top of the SIMM
module towards the left side of the printer until the SIMM becomes
free of the side clips. Lift up and pull the SIMM out, being careful
not to damage the fingers on the top. See Figure 5-5.
Integrated circuits may become weakened or damaged
by electrical discharge. Do not touch or work near inte-
grated circuits without wearing an ESD wrist strap.
NovaJet PRO 600e Service Manual
Assembly\Disassembly 5-9