Remove Extra Memory (Simm) - ENCAD 60e Service Manual

Remove Extra Memory (SIMM)

1. Perform steps 1 through 9 of the Remove the Left, Top, and
Right Covers procedure to remove the Top and Right Covers.
Figure 5-5. Extra Memory (SIMM) Installation/Removal.
2. The SIMM slots are at a 90° angle from the main circuit
board. Facing the top of the SIMM, push the side clips gently
to the outside (away from the SIMM) then push the top of the
SIMM module towards the left side of the printer until the
SIMM becomes free of the side clips. Lift up and pull the
SIMM out, being careful not to damage the fingers on the top.
See Figure 5-5.
Integrated circuits may become weakened or dam-
aged by electrical discharge. Do not touch or work
near integrated circuits without wearing an ESD
wrist strap.
Novajet PROe Series Service Manual
Assembly\Disassembly 103