Table of Contents
Advertisement
8. Tighten the screw on the left side of the stabilizer.
9. While lifting up the measuring tip of the micrometer, slide
10. Move the left end of the stabilizer bracket until a reading of
11. Tighten the screw on the stabilizer that is next to the
12. Continue performing steps 10 through 12 until all four of
13. Reposition the Carrier to all of the adjustment positions
14. Perform steps 6 through 14 as many times as necessary to
Color Calibration
This procedure describes how to check that the cartridges are
properly aligned for color plotting and should be followed each time
the ink cartridges are installed. Figure 3-18 is a representation of
how a color calibration looks when printed.
NOTE
The measurement of 0.075" instead of 0.065" as stated
earlier is used due to the fact that the test cartridge
does not contain a jet plate assembly. A 0.010" differ-
ence had to be added to compensate for the lack of a
jet plate assembly on the test cartridge.
the Carrier to the right until the next stabilizer screw is
lined up. Position it as close to the screw as possible and
drop the measuring tip onto the platen. Do this a couple of
times to ensure an accurate reading.
0.075" +/- 0.003" is observed. Read only the RED numbers
on the micrometer gauge.
Carrier.
the stabilizer screws have been adjusted.
and verify that the measurements are correct.
correctly accomplish this adjustment.
Novajet PROe Series Service Manual
Maintenance
63
Advertisement
Table of Contents
