BT REFLEX RR B Service Manual page 96

10- 2
Electric pump motor –1710
Dismantling and assembling the pump motor
T-code
403-414, 669-671, 716-718
Date
2005-06-01
10.3 Dismantling and assembling the
pump motor
To open and close the motor compartment, see section P1 in this manual.
3
10.3.1 Dismantling
6
• Lower the forks to the lowest position to reduce pressure in the hos-
7
es and pump.
• Disconnect the battery plug.
12
4
• Pump the oil out of the hydraulic tank (3) with filter pump V10-15191.
• Remove the support (4) so that the bolts (5) for the pump mounting
(12) are accessible.
• Remove the temperature/speed measuring contacts (6) and power
cables (7) from the motor (8).
• Remove the hydraulic hose (9) and loosen the hose clamp for the
hydraulic hose (10) which is attached to the tank.
• Fasten a lifting eye in the motor axle.
• Remove the bolts (5) holding the pump mounting (12) to the chassis.
• Lift out the hydraulic pump and place it on a clean surface.
• Remove both mounting attachments (12) from the pump motor (8).
• Remove the screws and dismount the pump (13).
• Remove the carrier.
10.3.2 Assembling
• If the O-ring on the pump is damaged, it should be replaced.
• Replace the carrier between the pump and the pump motor (8).
• Replace the pump unit (13) on the pump motor (8).
• Replace both mounting (12) attachments on the pump motor (8).
• Screw a lifting eye into the end of the motor axle and connect it to an
8
overhead crane.
• Lift the hydraulic pump into the truck while at the same time refitting
the hydraulic hose (10) on the tank (3).
• Tighten the hose clamp.
• Fasten the two pump mountings (12) to the chassis using the bolts (5).
13
• Unscrew the lifting eye.
• Refit the hydraulic hose (9) and the temperature/speed metering
contacts (6) and the power cables (7).
• Fill the hydraulic tank (3) with new oil.
Service Manual
https://www.forkliftpdfmanuals.com/
Valid from serial number
713962-
Order number
218920-040
REFLEX RR B/E, RR B/E CC © BT Europe AB